Geeetech Mizar DIY 3D Printer with 3.5-inch UI Color Touch Screen and TMC2208 Silent Drivers 220X220X260mm

Highlights

Self-Developed TMC2208 Silent Drivers
The motherboard in Geeetech Mizar DIY 3D Printer is equipped with a TMC2208 silent driver, which can greatly reduce the noise of the X-axis and Y-axis motors during the printing process. The noise of the whole printer is <50dB, It is convenient for you to use the printer in any occasion, without worrying about the problem of excessive noise.

32-Bit MCU and Higher Precision
There is 32-Bit MCU in motherboard of Geeetech Mizar DIY 3D Printer, 32-Bit MCU can ensure higher frequency and better performance than AtMega 2560. Although the frequency of the printer is higher but the printing accuracy is not reduced, the high printing accuracy of Geeetech Mizar DIY 3D Printer can reach - 0.1mm.

Printing-Resuming
Geeetech Mizar comes with a filament detector and break-resuming capacity, if the electrical power is off, prints can be resumed from the last layer, saving your time and reducing the waste. When you want to continue printing, just reconnect the power.

New Hot End Design
Mizar uses two large-volume and low-noise cooling fans, which improves the heat dissipation performance and effectively reduces wind noise. The hot-end throat structure can greatly reduce the probability of filament blocking.

3.5in Color Touch Screen
Geeetech Mizar DIY 3D Printer comes with 3.5-inch color touch screen, the newly upgraded UI design provides users with a more concise interaction. Users can directly touch the screen to operate the printer, which is better than traditional screens.

Specification